Blood clot test
Blood clot test

Bleeding time

Definition:
This is a test that measures the speed in which small blood vessels close off to stop bleeding (the condition of the blood vessels) and platelet function.

How the test is performed:
A blood pressure cuff is placed on the upper arm and inflated. Two incisions are made on the lower arm. These are about 10 mm (less than 1/2 inch) long and 1 mm deep (just deep enough to cause minimal bleeding). The blood pressure cuff is immediately deflated. Blotting paper is touched to the cuts every 30 seconds until the bleeding stops. The length of time it takes for the cuts to stop bleeding is recorded.
How to prepare for the test:
Adults:
Certain medications can interfere with platelet function and there fore test results. Your doctor may ask you to discontinue these medications several days prior to the test. Always make sure to tell your doctor what medications you are taking, even over-the-counter preparations.

Infants and children:
The physical and psychological preparation you can provide for this or any test or procedure depends on your child's age, interests, previous experiences, and level of trust. For specific information regarding how you can prepare your child, see the following topics as they correspond to your child's age:
How the test will feel:
The incisions are very shallow and feel like a scratch.
Why the test is performed:
This test is useful for detecting bleeding tendencies.
Normal Values:
The bleeding stops within 1 to 9 minutes. This may vary from lab to lab, depending on how the test is measured.
What abnormal results mean:
Prolonged bleeding time may indicate:
  • A vascular (blood vessel) defect
  • A platelet function defect (see platelet aggregation)
  • Thrombocytopenia (low platelets)
Drugs that may increase bleeding times include dextran, indomethacin, and salicylates (including aspirin).

Additional conditions under which the test may be performed:
What the risks are:
There is a very slight risk of infection (because the skin is broken). Excessive bleeding is rare.
Special considerations:
The bleeding time test is used to evaluate the vascular (blood vessel) and platelet factors associated with hemostasis (blood clot formation). When vascular injury occurs, the first hemostatic response is a spastic contraction of the lacerated vessels. Next, platelets adhere to the wall of the vessel at the area of laceration in an attempt to plug the hole. The failure of either process results in a prolonged bleeding time.

Review Date: 10/31/2001
Reviewed By: Rebecca Elstrom, M.D., Division of Hematology-Oncology, University of Pennsylvania Medical Center, Philadelphia, PA. Review provided by VeriMed Healthcare Network.
A.D.A.M., Inc. is accredited by URAC, also known as the American Accreditation HealthCare Commission (www.urac.org). URAC's accreditation program is the first of its kind, requiring compliance with 53 standards of quality and accountability, verified by independent audit. A.D.A.M. is among the first to achieve this important distinction for online health information and services. A.D.A.M. is also a founding member of Hi-Ethics (www.hiethics.com) and subscribes to the principles of the Health on the Net Foundation (www.hon.ch).

The information provided herein should not be used during any medical emergency or for the diagnosis or treatment of any medical condition. A licensed physician should be consulted for diagnosis and treatment of any and all medical conditions. Call 911 for all medical emergencies. Links to other sites are provided for information only -- they do not constitute endorsements of those other sites. Copyright 2003 A.D.A.M., Inc. Any duplication or distribution of the information contained herein is strictly prohibited.